Guides

Setup guides

Each guide covers the wiring and the setup in that platform's own software. The EG5 and EG12 put out 0 – 5 V, so they work with any ECU or data logger that reads a 0 – 5 V sensor. The CAN4 sends its readings in two CAN frames whose identifiers, bit rate and byte order are settings, so it can be set up for an ECU, dash or logger that reads a user-defined CAN frame of 8- or 16-bit values. It has not yet been run on an ECU.

EG5 and EG12 · EGT amplifiers

• MegaSquirtMS3, MS3Pro and MS2/Extra, in TunerStudio
• SpeeduinoA local aux input, in TunerStudio
• HaltechNexus and Elite analog voltage inputs, in NSP
• Link ECUG4X An Volt inputs, in PCLink
• AEM InfinityA spare analog input and a virtual channel, in InfinityTuner
• Holley EFITerminator X, HP and Dominator, as a custom 5 V sensor
• MaxxECU0 – 5 V analog inputs as an EGT sensor, in MTune
• RaceCaptureRaceCapture/Pro and Apex analog channels
• EFILiveFlashScan V2 and HD: V3 and AutoCal V3 have no analog inputs
• HP TunersPro Link+ analog inputs, in VCM Scanner

CAN4 · analog-to-CAN module

• Link ECUG4X and G5, a Receive User Stream in PCLink. Written from Link's documentation, not yet run on an ECU
• Haltech NexusNot the Rebel. Generic CAN in NSP 1.48 or later. Written from Haltech's documentation, not yet run on an ECU
• Haltech Nexus Rebel, EliteNot supported: neither takes a user-defined CAN frame

What an ECU needs to read the CAN4: CAN, and what differs between ECUs. The CAN4's settings are made on its own setup page.